EXTERIOR PRIMER

AMBIANCE EXTERIOR PRIMER

AMBIANCE EXTERIOR PRIMER is water thinnable primer. It is suitable for Exterior and Interiors plastered walls, asbestos, cement concrete etc. as a primer coat. The product is made from fine inorganic fillers, Additives, Polymers, etc. This product can be used as a primer prior to any water based paint application.

Coverage1 COAT – 110- 120 SQ FT/Lt.
Drying time4-5 Hrs
Flash pointNA
Stability of thinned paint24 hrs
AppearanceWhite, Liquid, Smooth
Specific Gravity1.4
Viscosity@25°C2350 CP
Pot life24 hrs
Contrast Ratio95.6

SURFACE PREPARATION

  • If the plastered wall is new, check the curing and absorption. The absorption of plaster is high then cure the plaster with water
  • Remove dust particles and loose plaster with sand paper.
  • If the plaster has already coated with lime wash, paint, etc. must be scrapped.
  • The scrapped wall must be washed with water and it should free from loose dust, old
  • Paint and plaster particles.
  • Fungus affected areas must be scraped or treat with special chemical before Application of paints.

TECHNICAL
DATASHEET

APPLICATION PROCEDURE

  • For best results fill the porous & cavities with putty in the plaster.
    If required full putty coat can also be done on the entire plaster.
  • Ambiance Primer is a paste and water to be added to the paste under stirring to obtain brushing consistency. As per recommendation , the dilution ratio is 1ltr. of primer with above 350 ml. of water.
  • Apply a coat of primer and leave it for 6 hours drying before painting
    Avoid application during raining and also when walls are in wet conditions.
TOP